PDA

View Full Version : Square grip --> Rectangular grip


tenniko
04-30-2007, 08:50 PM
I know many of you who hate Head grip have taken measures to make it more square and rounder, but has anyone tried making a square grip (i.e. Prince) into the grip shape of Head/Volkl grip?

If so, then how did you do it?

(It'd be great if anyone actually did it with POG, but that's asking for too much)

Noveson
04-30-2007, 08:55 PM
Just take the non heat shrink ways to increase the grip size, but only put them on the two bevels, so it creates a more rectangular shape. You could even just take of the grip and put duct tape on the bevels.

stormholloway
04-30-2007, 09:18 PM
Yeah. Get the non shrink Add-On and pick your bevels. Works like a charm.

Noveson
04-30-2007, 09:22 PM
I got that from your post in the other thread storm;)

stormholloway
04-30-2007, 09:25 PM
I got that from your post in the other thread storm;)

I knew it!

Noveson
04-30-2007, 09:38 PM
Haha sorry sorry. I will should have given credit where credit is due:)

stormholloway
04-30-2007, 09:46 PM
Yeah uh... I invented that procedure. Just like I invented the artificial heart.

tenniko
05-01-2007, 01:32 AM
wouldn't that procedure increase the grip size of the racquet?

and i don't see how one can take the grip off of POG...

foggie
05-01-2007, 04:26 AM
I modded it to a wilson-like grip, add tapes to all beveals except the top and bottom.
The grip size increased so much that I have to remove the leather grip and use one over grip only to keep the same size. Later I added some lead at butt to keep the balance while reduced the total weight :)

BTW what do you all think the differences between adding tapes like me and only add to the side beveals?