PDA

View Full Version : Dimensions of Base for Alpha Revo?


indyfob2008
09-05-2010, 07:59 AM
I am shopping for a microwave or printer stand for my new Alpha Revo 4000. My stringer should arrive Thurs or Friday. Does anyone know the dimensions of the Revo 4000 base? I saw a cart at IKEA, and the dimensions of the table top are 23x19... will this be big enough?
thanks.

indyfob2008
09-05-2010, 11:16 AM
also, does anyone know how much the Revo 4000 weighs?

tennisman917
09-06-2010, 12:29 AM
about 70lbs

Centryx
09-06-2010, 09:14 AM
dimensions of the base are 25.5 x 15

dancraig
09-06-2010, 11:09 AM
http://tt.tennis-warehouse.com/showthread.php?t=340633&highlight=revo+stand

coachrick
09-06-2010, 03:09 PM
about 70lbs

That is ONE dense tabletop, if it weighs 70#. My SP11 was in that ball park but would make THREE Revos :) .

indyfob2008
09-06-2010, 03:10 PM
crap. I have to go out and buy another cart. my ikea cart is length 23". wait. it might work out, depending on how the bottom side of the base is designed. Does anyone have a photo of the bottom side of the base? (or a basic description of how it is designed; completely flat? or 4 corner rubber pads?)

tennisman917
09-07-2010, 09:44 AM
http://tt.tennis-warehouse.com/showthread.php?t=327163&highlight=alpha+revo+4000

If you take a look at this thread there are pictures of the revo dissembled and assembled . it will help u with wat you are looking for

coachrick
09-07-2010, 04:20 PM
This is really a reach...you may be able to fashion something that will work size-wise AND make the cart a bit more convenient. I built a 'riser' (like an old keyboard cubby or platform you might use to raise your flatscreen up to make room for a DVR, etc underneath). The 'legs' of the riser would be placed an inch or two narrower than the cart top BUT the platform on top of the legs would be wide enough for your machine. This would give you a shelf under the platform, more convenient than opening the drawer each time, IMO. I did this when I had my giant SP11 on top of a microwave cart. It raises the platform height by whatever amount you make the legs(in height).

This only make sense if you have some sheet goods available and are interested in a bit of a project. An easier but less 'useful' approach would be to place a board(wide enough) flat on top of the M/W cart. It would need to be secured to eliminate sliding...just an area rug pad or spongy shelf liner would hold the board in place.

This assumes you want to keep the cart and work with it. I was happy with my set-up even though I've downsized to a MS200tt and don't need the extra width platform. BTW, my M/W cart is 25.5" x 18" (from Cost Plus/World Market)