Best method to remove paint

Discussion in 'Racquets' started by klementine, Feb 9, 2012.

  1. klementine

    klementine Hall of Fame

    Joined:
    Apr 29, 2008
    Messages:
    4,116
    Location:
    DcMdVa
    I've probably skimmed through and read all the threads there are on the 'How to's' of re-painting a racquet.

    Everyone chooses one of the two methods (sanding or stripping) to remove the paint from a racquet. But I still have not found a resounding answer. Will paint stripper harm the graphite or racquet materials?

    TIA,
    Klem
     
    Last edited: Feb 9, 2012
    #1
  2. scotus

    scotus Legend

    Joined:
    Jul 5, 2005
    Messages:
    7,528
    I have never used it, but I hear carbolift is safe.
     
    #2
  3. klementine

    klementine Hall of Fame

    Joined:
    Apr 29, 2008
    Messages:
    4,116
    Location:
    DcMdVa
    ^ Thanks. Will look into it.
     
    #3
  4. esgee48

    esgee48 Hall of Fame

    Joined:
    May 30, 2010
    Messages:
    2,204
    Location:
    SF, CA
    Methylene chloride solvents can damage resins if left on for hours. 10-15 minutes, not! I would stick with calcium hydroxide or limonene based removers because they're less toxic and less likely to damage the frame's resins/graphite. These will remove paint by lifting them from the surface. You still need to mechanically rub off the mess and or use steel wool. It's a long process (more than 60 minutes) and you should do it in a ventilated area.
     
    #4
  5. 6-2/6-4/6-0

    6-2/6-4/6-0 Semi-Pro

    Joined:
    Jun 2, 2011
    Messages:
    697
    Location:
    about 5000 feet up...
    I know a lot of people in the cycling world who have used carbolift with very good results. That would be my first recommendation. Then wash the racket well and wet sand anything that is still a bit less than perfect. Something like a 400-600 grit should be good.
     
    #5
  6. Hi I'm Ray

    Hi I'm Ray Hall of Fame

    Joined:
    Feb 26, 2010
    Messages:
    1,504
    I tried using citri-strip as it is less toxic. I experimented on an old wilson that was part aluminum, part carbon fused together. It takes several hours for the paint to soften enough and you will need something like steel wool to scrap it off. I also noticed that the graphite sections weren't perfectly shaped on the surface so they used some kind of filler (reminded me of bondo) to get the surface smooth. At first I thought it was a layer of primer. Some areas just would not come off with the paint stripper so I had to use light sand paper. It looked smooth but I just know it was going to be uneven because the frame is curved I could not use a tool to get more uniform results. The solvent did not soften the graphite of this particular racket.

    However, I placed a drop on the handle of my Wilson Profile which has no foam on it, its just the bare graphite - its braided graphite with a layer of clear resin over it, like you see with many frame nowadays. After a few hours I wiped off the drop of solvent and resin was soft (it hardened again afterwards) so there is definately a potential of damaging your frames or changing the stiffness when using a solvent.
     
    #6

Share This Page