Discussion in 'Strings' started by spinbalz, Mar 2, 2004.
Do I have to enlarge a hole? If yes which one do you advise?
no you do not have to enlarge any holes
Length 2 pc 20ft x 17ft
Start mains Throat
Skip 8T and 8H
Tie off mains 6T
start 2 pc 8H - starting knot at 7H
last 2 pc 8T
tie cross 2pc 4T
I just bought a Dunlop 300G MP and also found a problem when stringing it in 2 pieces.
The stringing instruction given buy Dunlop is fine but the only problem was unable to tie off X at 7T. Hole 7T is so small and it is impossible to get the X string through. (I was using a 18 gauge string).
It works if I tie off X at 4T. But it is not so nice since X string spans from 8T to 4T to tie off.
Is this a design defect of 300G?
I do the same thing. I dont' know why dunlop would release that stringing pattern. Does everyone tie off at 4t? i think its a long stretch as well.
Separate names with a comma.