HELP PLZ: quick hybrid question

Discussion in 'Strings' started by nhstennis, Dec 18, 2006.

  1. nhstennis

    nhstennis Semi-Pro

    Joined:
    Sep 20, 2006
    Messages:
    460
    I have a set of technifibre polyspin 16 and gosen ogsm 16 that i am goin to hybrid. What is a good tension for the maINSs and crosses?
    aNY HELP is appreciated!!!!
     
    #1
  2. plarazza

    plarazza Rookie

    Joined:
    Sep 27, 2006
    Messages:
    133
    Depends on a few things really. How do you normally have them at? and what are you wanting, better control, more power etc
     
    #2
  3. looseswing

    looseswing Professional

    Joined:
    Apr 30, 2006
    Messages:
    1,340
    Location:
    Garden State
    I would say go for the tension you normally use, and it is customary to string the poly lower than the other string.
     
    #3
  4. TalkingTennis91

    TalkingTennis91 Semi-Pro

    Joined:
    Jul 25, 2006
    Messages:
    469
    What kind of racquet are you using?
     
    #4
  5. nhstennis

    nhstennis Semi-Pro

    Joined:
    Sep 20, 2006
    Messages:
    460
    It is a N-six one tour 90. I usually string it with enduro pro at 55 lbs. What tension for M and X's would give me the same feel and control I was thinking
    57-58 M and 60+ for crosses. Opinions plz!!!!!!!!!
     
    #5
  6. plarazza

    plarazza Rookie

    Joined:
    Sep 27, 2006
    Messages:
    133
    Try the m's at 55 and crosses at 57. Wont last a long time on the duribilty side as much but See how u like it if not just experiment a bit until u find a setup u like.
     
    #6
  7. looseswing

    looseswing Professional

    Joined:
    Apr 30, 2006
    Messages:
    1,340
    Location:
    Garden State
    I'm no expert by I suggest trying the poly at 54 and the gosen at 56 if you like enduro at 55.
     
    #7
  8. nhstennis

    nhstennis Semi-Pro

    Joined:
    Sep 20, 2006
    Messages:
    460
    for no pro you sure do have a lot of posts
    I have a Prince P-200 and its starting to leak air therefore constantly trying to maintain tension. THe tension has been ununiform lately; If i calibrate it and the pull doesnt match, wat action is taken afterwards?
     
    #8

Share This Page