Stringing NXG Mid+ or any racket that has 16X20 pattern

Discussion in 'Strings' started by Thunnus, Mar 7, 2004.

  1. Thunnus

    Thunnus Rookie

    Joined:
    Feb 20, 2004
    Messages:
    237
    It looks like all 16X20 rackets require you to do one-piece string job only. I have figured out how to string with two piece string job with Pure Conrol but I have not found a way to string my new NX Graphite Mid+.

    I would really appreciate it if someone would let me know if it is possible to do a two-piece job on the Prince NXG Mid+.
     
    #1
  2. Steve Huff

    Steve Huff Legend

    Joined:
    Feb 11, 2004
    Messages:
    7,266
    Try using an around-the-world pattern.
     
    #2
  3. Hawaii 5.0

    Hawaii 5.0 Rookie

    Joined:
    Feb 16, 2004
    Messages:
    299
    The NXG Mid can't be strung 2 piece unless you share one of the throat holes used for tie off on the mains for the crosses as well(can be done), but I don't know if it's that good for a frame or if Prince will allow it. As far as doing it one piece without doing it bottom up for the crosses I suggest rather than the traditional ATW or box pattern which usually involved grommet enlarging(can't be done with the Prince More Performance Construction,without putting the frame at risk since the grommets are premade with no grommets to enlarge.By the way the NXG Mid is 18X20 and should be done this way imo.Do the SS mains as you normally would and the LS mains only do 8 mains and begin the crosses and when you get to the bottom the last cross shoud end up on the LS where the last main is missing and can be done last.I like this becuase it doens't require grommet enlargement, allows for outter mains to be tie offs,makes use of original tie offs, and top down stringing.Not all 16X20 patterns suggest s 2 piece, but I'm not as sure on the MP string pattern so I'll check and post tomorrow if you can do a two piece or if it's like the Mid.
     
    #3
  4. gjones

    gjones New User

    Joined:
    Feb 23, 2004
    Messages:
    19
    If I read your message correctly you are looking for a two piece method. USRSA has this for two piece.

    PRINCE Tour NXGraphite MP 20'x18' 55-65 16x20
    Start mains at Head
    skip 7T,9T & 7H,9H
    main tieoffs 8H
    start crosses 7H
    end crosses 7T
    cross tieoffs 6H,9T

    Note: Grommet 10H has two holes in a single barrel. One string per hole required.

    Currently you can access the USRSA website: www.racquettech.com
    with a temporary password you might want to look under Tools then Digest Search.
    You can then search for string patterns by Company and Model.

    Hope this helps
     
    #4

Share This Page