Thread: Eagnas?!!!!
View Single Post
Old 09-14-2008, 03:09 PM   #33
mellofelow
Semi-Pro
 
Join Date: Sep 2005
Posts: 446
Default

Quote:
Originally Posted by Zhou View Post
There should be a calibration screw so that you can make 60 lbs = 60 lbs by turning the screw left or right.
2 screws to be exact. One set screw and one adjustment screw. In practice, it's not that easy... at least not the Eagnas because the set screw loosening and tightening will change the setting a few lbs.

I believe there's a third adjustment... I can't remember but since the spring tension is exponential, the spring rate needs to be adjusted too. If incorrect, the dial could be 60 on the mark, however it's off incrementally at 50 & 70 for example.
mellofelow is offline   Reply With Quote