View Single Post
Old 08-01-2012, 09:21 AM   #9
Join Date: Jan 2012
Posts: 574

Bar Clamp. Must be this type, not this.
Duct Tape
Plank of Wood
Vernier/Dial Caliper. Must come with a depth rod like this.

Step 1 -

Ensure the depth rod on the caliper is as far down as it can go. Tape the top of the caliper to the bottom of the plank.

Step 2 -
Clamp the plank of wood to the table, so that the depth rod touches the floor. Place a heavy book on the bar clamp to secure it. Now read the measurements on the caliper.

Step 3 - Place the shoe underneath the rod. Then move the rod down, until it touches the insole of the shoe. Re-measure the caliper.

Last edited by newyorkstadium; 03-25-2013 at 07:33 AM.
newyorkstadium is offline   Reply With Quote