View Single Post
Old 10-01-2012, 01:12 PM   #9
Roger Wawrinka
Roger Wawrinka's Avatar
Join Date: Aug 2012
Location: So Cal
Posts: 1,028

Hey guys, I tried to use the awl method as shown above but I just did not like it cause the lead around the edges of the grommets were chipped and frayed. Then I used a single hole puncher again shown above but the hole it makes is to big. Any other ideas?

I know this is not what were talking about right now, but I wanted to ask about changing a butt cap. Is it safe to just pull the staples out and put a new one on? Will it damage the frame? Also, what would I use to put the staples back in?


Last edited by Roger Wawrinka : 10-01-2012 at 05:03 PM.
Roger Wawrinka is offline   Reply With Quote