View Single Post
Old 10-01-2012, 11:25 PM   #11
slowfox
Professional
 
Join Date: Oct 2011
Posts: 1,111
Default

Quote:
Originally Posted by Roger Wawrinka View Post
Hey guys, I tried to use the awl method as shown above but I just did not like it cause the lead around the edges of the grommets were chipped and frayed. Then I used a single hole puncher again shown above but the hole it makes is to big. Any other ideas?
R.W
My second attempt to help...

Measure the distance of the holes you need, mark it on the lead tape before sticking it on, cut out small clean holes with an x-acto knife, then apply to racquet.
slowfox is offline   Reply With Quote