View Single Post
Old 10-09-2012, 10:45 AM   #15
Irvin's Avatar
Join Date: Mar 2007
Location: Marietta, Ga
Posts: 9,805

Originally Posted by lynnbart View Post
Is it hard to change the clamp bars when switching from mains to crosses on the Neos 1000 ?
It should not be if your mains are tied off. The guide bars are on the top and bottom of the turntable when doing the mains and on the sides of the turntable when doing the crosses. You can't have one on the top and bottom and another on the side at the same time.

So if you're doing a one piece job you need to tie off one side or hold it with a starting clamp and pull tension on the other to move the clamps to hold the crosses.
I have the ability to drive people crazy, not sure if I was born with it or I learned it but I'm damn good at it.
Irvin is offline   Reply With Quote