When stringing the O3 rackets I like using the two piece 50/50 method. A 50/50 WILL NOT WORK. That way all you need is a Klippermate and nothing else. if you want to string your racket one piece mount the frame down in the stringer so the throat support is as close to the end of the bar as possible. This gives you fewer O ports above the pivot point and reduces the problem. Then use your boomerang or anything (sharper cap) to keep the strings properly spaced and there is no problem.
When you're dead you don't know you're dead. It's the same way when you're stupid.
Balance - 31.0 cm, Weight - 358 g, SW - 346 Kgcm^2
Last edited by Irvin : 11-21-2012 at 11:59 AM.