View Single Post
Old 12-13-2012, 10:09 PM   #15
Join Date: Mar 2008
Posts: 965

Well I couldn't wait for the boomarang tool to make it here so just strung 2 piece 50/50 method which worked out easily enough, only one cross had really any angle on it and it wasn't too bad.

The hardest part on that racquet was getting a soft thin multifilment string NRG2 17 gauge to get it back thru a hole covered by an existing string. Those grooves are so beveled in there, it makes it tough to move the existing string so you can get your string end thru there without mashing it, becoming soft and useless. Wouldn't be a problem with most mono or stiffer strings but that was tough. Any suggestions to alter the grommet to make next time easier like really pressing an awl into it.?
Thanks again for your tips.
robow7 is offline   Reply With Quote