View Single Post
Old 01-05-2013, 04:05 PM   #57
enderx1x
New User
 
Join Date: Apr 2012
Posts: 67
Default

Quote:
Originally Posted by EastAngels2014 View Post
So i am doing a one piece on my new stringer and i am done with the mains and not sure how to do the crosses, where do i put the clamps?
You will have to do the first 2 crosses, pull, and then clamp them to eachother. Make sure to wiggle the crosses when you are pulling 2 at once (and this should be the only time you do) to get the tension as close as possible. Then pull 3rd cross and clamp it to the 2nd.
enderx1x is offline   Reply With Quote