View Single Post
Old 01-21-2013, 04:35 PM   #10
leroy_sunset
Rookie
 
leroy_sunset's Avatar
 
Join Date: Aug 2011
Posts: 337
Default

I have thought about doing this for my HGE. Simple, 1 piece strip in an aluminum mold. Use some soft-ish plastic resin (similar to a 2 part epoxy). Drill out the grommet holes on a drill press when it's done, and then heat the strip with a heat gun to install. I'm pretty sure I could get it to work. Haven't got the shop setup to do it yet. Maybe in a few years.
leroy_sunset is offline   Reply With Quote