View Single Post
Old 01-27-2013, 05:27 PM   #7
Hall Of Fame
Lakers4Life's Avatar
Join Date: Jul 2009
Location: Laker Land
Posts: 3,638

Originally Posted by EastAngels2014 View Post
but if i cut 21' i wont have enough cause the other half will be 19' so do i just not use that for main? and i don't have a starting clamp. so how do i use the floating clamp as a bridge?
You can always use it for a cross.

Do yourself a favor and get a starting clamp. It will save you a lot of headaches like this.

To use a floating clamp as a bridge. Clamp the end you want to pull, and clamp the scrap string on the other side. You may want to put a knot on the end just in case it slips. Then just cut the knot afterwards.

Though I foresee another problem, you might not have a free floating clamp.
Machines: Gamma 6004 2-point w/ Wise 2086 & Babolat Sensor Dual
Lakers4Life is offline   Reply With Quote