Thread: MRT preparation
View Single Post
Old 01-30-2013, 11:01 AM   #16
kkm
Semi-Pro
 
Join Date: Feb 2008
Posts: 607
Default

Quote:
Originally Posted by ten11 View Post
I will practice remove grommet more just use pliers. The test is about to use right technique and got its reason. I need to be good at it to pass.
Thanks for the wonderful advise of paying attention to the strings. These are the advise I am seeking.
I think I should able to tell them by looking at the string. One is solid core and the other is not. Any other better way and sure way to tell them apart? coil memory? softness? Can I ask the tester and mark it? or it is part of the test to tell them apart?

To some extent you could probably tell the difference by looking. One is monofilament polyester, the other is natural gut. As far as telling them apart, the tester will not tell you which is which, and you will not know until you finish stringing the racquet whether your choice was correct. So basically it is part of the test. If you have any doubt before prestretching what you think is the natural gut, you could do one or more of a couple different things, snip a small piece of the string at a diagonal and see if you can separate the strands (natural gut is made up up several strands), or near one of the ends of the string, see how much the string resists being pinched into a "v," the monofilament polyester should resist this more.
You shouldn't need a yardstick, and forget about taking a magnifying glass, a general naked-eye visual inspection should be good enough (all you have to do is sort of pretend to inspect anyway), and you'll be given a synthetic replacement grip with adhesive backing, so you shouldn't need doublesided tape. I would take a blunt awl along instead for straightening the strings. You should at least try to straighten the crosses as you go along. Straighten the mains too, even if it's only at the end after you finish the crosses.
Remember to hold the first grommet where the string exits the frame from the bottom in place with your thumb when the string is being tensioned, and remember to hold the knot tail up before releasing the machine clamp before trimming the knot tail, the tester will be looking out for these things.
kkm is offline   Reply With Quote