View Single Post
Old 04-09-2013, 01:43 PM   #25
Irvin
G.O.A.T.
 
Irvin's Avatar
 
Join Date: Mar 2007
Location: Marietta, Ga
Posts: 10,652
Default

Quote:
Originally Posted by Rabbit View Post
What does that even mean? How can one mount a racquet higher on the turntable and how can anything decrease the number of crosses on a frame without the obvious, skipping holes.
When pulling crosses on a Prince O Port once you get past the pivot point on the turn table the crosses will pull to the bottom of the port. I did not say anything about decreasing the number of crosses.

If you move the two standards towards the bottom of the racket there will be fewer crosses at the top of the frame above the pivot point therefore you will have fewer crosses naturally pulling in the top of the port. RSI had a tip on that once a few years ago.
__________________
When you're dead you don't know you're dead. It's the same way when you're stupid.
Balance - 31.0 cm, Weight - 358 g, SW - 346 Kgcm^2
Irvin is offline   Reply With Quote