Eagnas Combo 710 loose clamp

Andyroo10567 · 11-08-2012, 10:29 AM

( Not an experienced stringer ) Is there any way to fix a loose clamps on this?
Thanks.

Lakers4Life · 11-08-2012, 02:44 PM

There is a video of it on YouTube. But basically there is an access hole that you use a 3mm allen (hex) key. You'll need to line up the access hole in the Cone. It's easier to see if the disc cap is off. Like in the picture below.

The Allen key will turn an angled piston that pushes the cone to lock the clamp. Tightening the bolt and slot nut, may help, but it's a very coarse adjustment. The Allen key is a finer adjustment.

Andyroo10567 · 11-09-2012, 08:16 AM

Thanks Lakers4Life! Will be working on it by Sunday i hope.

tbuggle · 11-09-2012, 10:14 AM

with clamp still mounted, turn it toward the middle of the table so the hole/plug faces 90 degrees toward the edge of table to access the fine adjustment screw.

Lakers4Life · 11-09-2012, 07:19 PM

Eventually you will want to replace the base clamps, because you will be constantly be adjusting your current base clamps. Pro's Pro came out with a Base Clamp similar to the Prince BCs, but they are sold out. The currently available BC is the V2, but it's more like the Gamma Quick Action BC (not the Switch Action Cam-Lock).

11-08-2012, 10:29 AM	#1
Andyroo10567 Semi-Pro Join Date: Nov 2011 Posts: 784	Eagnas Combo 710 loose clamp ( Not an experienced stringer ) Is there any way to fix a loose clamps on this? Thanks. __________________ Racquet : Prince Youtek 6.1 Tour 531g 17x19 Strings : Steel Wire ( 21G ) <- Prototype

11-08-2012, 02:44 PM	#2
Lakers4Life Hall Of Fame Join Date: Jul 2009 Location: Laker Land Posts: 3,638	There is a video of it on YouTube. But basically there is an access hole that you use a 3mm allen (hex) key. You'll need to line up the access hole in the Cone. It's easier to see if the disc cap is off. Like in the picture below. The Allen key will turn an angled piston that pushes the cone to lock the clamp. Tightening the bolt and slot nut, may help, but it's a very coarse adjustment. The Allen key is a finer adjustment. __________________ Machines: Gamma 6004 2-point w/ Wise 2086 & Babolat Sensor Dual Last edited by Lakers4Life : 11-08-2012 at 02:47 PM.

11-09-2012, 08:16 AM	#3
Andyroo10567 Semi-Pro Join Date: Nov 2011 Posts: 784	Thanks Lakers4Life! Will be working on it by Sunday i hope. __________________ Racquet : Prince Youtek 6.1 Tour 531g 17x19 Strings : Steel Wire ( 21G ) <- Prototype

11-09-2012, 07:19 PM	#5
Lakers4Life Hall Of Fame Join Date: Jul 2009 Location: Laker Land Posts: 3,638	Eventually you will want to replace the base clamps, because you will be constantly be adjusting your current base clamps. Pro's Pro came out with a Base Clamp similar to the Prince BCs, but they are sold out. The currently available BC is the V2, but it's more like the Gamma Quick Action BC (not the Switch Action Cam-Lock). __________________ Machines: Gamma 6004 2-point w/ Wise 2086 & Babolat Sensor Dual

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode