Irvin's latest activity

A big problem with a 50/50 pattern is you need to string 2 crosses toward the top then 2 toward the bottom and keep repeating until you...

Yes the string will bend but on the next pull I try to release the base of the clamp and straighten the string while tension is pulling...

Sounds like you were putting the peg on the cross and not the main or you have extremely small clothes pegs in the UK.

@graycrait if your tips are unraveling you must be push weaving and not pull weaving. I try to pull weave when stringing gut in crosses...

Were you putting the clothes peg on the outside main?

@wings56 measure your rackets using a cross string 3 strings off from where you measured them first and see what your SWs are. You may...

I would not use a stop knot without tying it around the anchor string that would put all the pressure of the stop knot on the grommet...

Why accept anything that will not be exact? As you surmised adding 10 g at the balance point will not change the balance and raise SW...

I don't use the boomerang tool. The 50/50 method on the crosses works just fine for me. Still, if someone has the files they can share...

@Gamma Tech - Thanks this makes sense. While I always did top down approach, bottom up approach isn't something i paid attention to. I...

I think I'll be close enough with my metric! Thanks for the info

Now I see the problem the solution to get you SW to 354 given by the TWU tool is in inches not cm. All your other measurements were in...

No the problem is you do not realize I did not give you the formula for the inertia of a physical pendulum. If you used some other...

Deleted

@wings56 look at it this was SW = RW + md^2 you’re going to need to increase mass from 330 g to 340 g and your balance will remain at...