Baiardo Tool tray

[MyAdvantage]

Hello,
Reaching out to see if anyone with a Baiardo machine might be able to assist. I bought a used machine and the owner gave me the bottom tool tray but did not provide the two screws that attached it.

Can anyone tell me what size screw I will need?

Thank you!

 

[Wes]

@MyAdvantage,

I don't know the size.
However, I'm invoking @Herb, @Standupnfall and @Dillon4787 (so that they'll receive a notification).

Any of those guys should be able to provide the answer here for you.

Cheers, Wes

 

[MyAdvantage]

Thanks much, Wes!

 

[Herb]

I cannot tell you the size, But if the nuts are still under the tray liner you can take one out and find a screw about an inch long that will fit. If the nuts are not under the liner then you can use anything you want as long as the nut fits in the hole. They are close to an inch long, but I will measure length when I get home and update. You may also check to make sure the screws are not in the mounting holes. That is where I keep them when I move a machine.

 

[SavvyStringer]

It's the same head size/allen key size as the ones that go into the top/base to connect them but it's longer. Maybe pop one out and take it to the hardware store with you. Like Herb said its probably an inch long so maybe a 20-25mm length.

 

[racquetlab]

The tool tray bolts are 1", the one attaching the top to the stand are 3/4". Can't verify if they're metric, but thread OD is 0.229"/5.8mm

BTW I ended up not installing the buttom tray as it seemed like a good place for string to get snagged.

 

[Wes]

The tool tray bolts are 1", the one attaching the top to the stand are 3/4". Can't verify if they're metric, but thread OD is 0.229"/5.8mm

BTW I ended up not installing the buttom tray as it seemed like a good place for string to get snagged.

Sounds like they're likely M6 bolts.

 

[mill]

M6 x 1, 25mm long, you'll need a hex nut as well