Grommet for the 2012 Pure Drive

haqq777

Legend
Hi guys,

Looking for grommets for a friend's worn down 2012 Pure Drive. Not sure which one to pick on TW website (if they even have grommets for the 2012). Will the 2015 ones fit? I also read I think that some APD or PA ones fit too? A little confused and unsure.

Can someone point me in the right direction please?

Cheers
 

mad dog1

G.O.A.T.
Hi guys,

Looking for grommets for a friend's worn down 2012 Pure Drive. Not sure which one to pick on TW website (if they even have grommets for the 2012). Will the 2015 ones fit? I also read I think that some APD or PA ones fit too? A little confused and unsure.

Can someone point me in the right direction please?

Cheers
Apd grommets also fit. The apd headguard is actually thicker than the pd headguards.
 

esgee48

G.O.A.T.
As of 10/19/2019, TW has these sets, which fit the PD model skipping 8T-8H
Babolat AeroPro Drive/Drive +/Team/Junior Black Grommet
Babolat Pure Drive/PDR/GT/+/Jr/Z/Lite/Tour Grommet [tip off is PDR[

MD already answered the OP, but just in case it is needed, the PDR Pure Drive Roddick will fit the original versions pre FSI.
 

dodu10

New User
I need the 6 holes throat grommet piece only for a babolat pure drive gt and my question is: would any of the 2015 babolat pure drive would fit that part? Thank you.
 

mad dog1

G.O.A.T.
I need the 6 holes throat grommet piece only for a babolat pure drive gt and my question is: would any of the 2015 babolat pure drive would fit that part? Thank you.
pretty sure the spacing is a little different but the throat grommet piece of the 2015 PD might fit if you modify the throat strip by cutting it down into pairs of two.
 

snoflewis

Legend
I need the 6 holes throat grommet piece only for a babolat pure drive gt and my question is: would any of the 2015 babolat pure drive would fit that part? Thank you.
i just tried this on a 2003 PD team which is supposed to have the same spacing as the GT. the 2015 grommets don't fit as a single piece. the spacing on the 2015 is just a tad wider.

pretty sure the spacing is a little different but the throat grommet piece of the 2015 PD might fit if you modify the throat strip by cutting it down into pairs of two.
i'm pretty confident this will work because i was almost able to get all the grommets through and out. i couldn't get the last 2-3 mms due to the spacing of the base of the grommets (where the woofers are) which was a little too wide as mentioned above. cutting it into 3 separate parts as @mad dog1 stated should fix it. the spacing is very similar though. also keep in mind the 2015 throat grommet is a slightly different design if that makes a difference.
 

Power Player

Bionic Poster
So basically there are no grommets out there for the PD12/ADP10 and 13 that fit exactly, and mods will have to be made?
 
Top