Head Speed Pro 18 x 20 (2017)

[Captain Karma]

Hey there!

I have a Head Speed Pro 18x20 (2017)

I am planning to do a 2 piece stringing job .( hybrid)

Kindly advise on the following :

Which are the Skip Holes ( Mains ) -

Which hole do I tie off the Mains

Where do I start my Cross double knot ? ( TOP / Bottom )

Thank you in advance ....




Sent from my iPhone using Tapatalk

 

[fjcamry]

Hey there!

I have a Head Speed Pro 18x20 (2017)

I am planning to do a 2 piece stringing job .( hybrid)

Kindly advise on the following :

Which are the Skip Holes ( Mains ) -

Which hole do I tie off the Mains

Where do I start my Cross double knot ? ( TOP / Bottom )

Thank you in advance ....




Sent from my iPhone using Tapatalk

Start the cross on top . There are no skipped holes for the frame .



Sent from my iPhone using Tapatalk

 

[tennytive]

A racket made in 2017 should also have the tie off holes identified. Look at your grommets in the throat area and you should see two that say main tie off. Most likely there will also be a cross tie off hole next to or near one of the main tie off holes as well.

 

[esgee48]

GRAPHENE TOUCH SPEED PRO [T=Tip of Hoop, B=Bottom of hoop]
GRAPHENE XT SPEED PRO
Range 48-57
Lengths 20'M - 19'C [Generous if nylon, add 1' if poly, though 40' is adequate if you do not pre-cut the strings]
Pattern 18M X 20C
Skipped Mains NONE
MTO 7B
1st X 8T
XTO 7T-10B
Shared Holes 8T 9T 8B 9B

Note the shared holes for mains and crosses. No mains to skip so 1-9 on each side. Mains tie off at 7B. Tie offs for crosses are 7T and 10B, a cross. To ensure that there are no crossovers, I normally shove a piece of scrap strip into the shared holes for doing the mains. This assures that the mains and crosses lay next to each other rather than inadvertently cross over.

 

[Steve Huff]

Make sure at the bottom that you don't tie off at the closest hole available. That's where the bottom cross goes.

 

[1HBHfanatic]

(2017)!?
what color is it?