i am trying to figure out a better way of doing the first cross on a one piece stringing job with floating (flying) clamps. the method i have been using thus far is double pulling the first two crosses but i just wanted to see if there was any other (more accurate) way to do this.
i searched the forums for an answer but the only thing i found was using a starting pin to clamp with the first cross. for this method, i am confused as of where to put the starting pin to clamp the first cross to. if i put the pin in the next cross then how do i weave the next cross? any help would be greatly appreciated!
i searched the forums for an answer but the only thing i found was using a starting pin to clamp with the first cross. for this method, i am confused as of where to put the starting pin to clamp the first cross to. if i put the pin in the next cross then how do i weave the next cross? any help would be greatly appreciated!