Solinco Falcon GT

gtwosweet

New User
Anyone have any clue on the Solinco Falcon GT stringing machine on how to check how many pulls on a machine, and if you can manually calibrate the machine. I know that it self checks it's calibration when you first turn on the machine. I've email Solinco they said they will get back to me but it's been a couple of weeks and no response so far. Any help is appreciated
 

Standupnfall

Semi-Pro
I could not locate the manual. A machine of that caliber should be supported with a manual, I would call/email and demand a manual.

Other than that by looking at the user interface have you tried holding down the knot button, or other button to see if you can get into a settings menu? The specifications do list "string pull counter".
 

uk_skippy

Hall of Fame
If its the same as other ExThree produced machines; hold the knot button for 5 seconds; then use the down arrow to cycle thru the screens. First page should be C-x, second page xxx third page xxx; full record will then be C-xxxxxxx. so a machine with 168 pulls would show as C-0; 000; 168 = total record C-0000168

Full calibration, again if the same as other ExThree machines, remove the key pad (not sure if the Solinco keypad is held in by hex screws; if so undo them) under the key pad will be the PCB's and on it you'll find a small block with a small screw. Thats the screw you use to calibrate the machine.

Hope this helps
 
Top