Search results

Thanks No photos from me to this forum.

Ok How that photo sharing should be done in Photobucket? It's quite new thing for me.

Not the rocket science I just cut 46 mm piece of 40 mm aluminium bar and made main 20 mm hole and two M6 holes for socket head screws as they were in an original plastic slider. Only little bit demanding thing was that the 20 mm hole must be quite accurate, 20 +0.1 +0.05 will do...

My Stringway system is under construction Will return with the photos when I get it done!!! My ML100 does't have that kind of bar in side slider (for cross strings). It's like one below. I have done that backslash elimination as mentioned but it doesn't help when the hole system...

And what I did I replaced the main plastic slider with the aluminium one. I changed the clamps and their bases to the "Babolat" style. I changed the slider 1 main beam to lower and stiffer. And of course counterpart also. In a one word the hole clamping system.

The hole clamping system Clamp, clamp base, slider system 1 and slider system 2. The hole chain. If you lookout the clamp it self the thinnest poist is there where it should be the thickest. Not really the cleverest design. Lookout how Babolat has built their clamping bases.

ML100 with a single action clamping I have had this machine for a while and clamping system sucks quite badly. They have engineered oddly. They have user plastic in main slider which takes the main load. The result is that clamping isn't stiff enough and the hole clamping system yields way too...